Every yard, by the numbers.
100% free tools About

YARD RULER / GRASS SEED AND FERTILIZER CALCULATOR

Grass Seed and Fertilizer Calculator

Measure the lawn once, then see how much seed, fertilizer, starter, and lime to buy. The rates start from university extension fact sheets, and you can replace them with the numbers on your bag. This is a general guide. Follow the product label, and for lime follow a soil test.

Free. Always free. No signup.

PLAN THE BAGS

Know how much seed, fertilizer, starter, and lime to buy.

Enter the lawn area, then use the bag in front of you or start from the extension rate shown for your grass.

⌂ Calculated on your device

Defaults match a 4,000 square foot tall fescue overseeding. Area can also come from the lawn square footage calculator.

Grass seed

University of Minnesota Extension suggests buying 10 to 20 percent more seed than the calculated amount to cover poor germination. The extra is off unless you turn it on, and it is applied to the seed pounds only.

Lawn fertilizer

The 0.75 pound default is a common early-spring rate on a cool-season lawn, from Iowa State University Extension’s April guidance and Purdue Turfgrass Science’s limit on quickly available early-spring nitrogen. The first number on the bag is the one used in the math. This planner caps a single fertilizer application at 1 pound of actual nitrogen per 1,000 square feet, the high end of Iowa State University Extension’s 0.5 to 1 lb of actual nitrogen per 1,000 sq ft per application. If your bag or soil test calls for more, split it into more than one pass.

Starter fertilizer, at seeding

The 1.0 pound default is the rate Michigan State University Extension and University of Illinois Extension describe at seeding. Starter fertilizer usually has a nitrogen-to-phosphate ratio near 1 to 1 or 1 to 1.5. Up to 1 lb of nitrogen per 1,000 sq ft for quick-release starters (Clemson HGIC 1203). Slow-release starters can go higher; follow the bag. Some states restrict phosphorus except at establishment or when a soil test calls for it. Follow your local rules and the bag label.

Lime, from a soil test

Leave the soil-test box blank until you have a lab recommendation. This planner will not invent a lime rate from a pH number. Use agricultural or pelletized lime; hydrated lime should not be used on a lawn. On established turf the default split uses a 50 pound per 1,000 square foot cap from University of Missouri Extension, UMass Amherst, and Wisconsin Extension publication A2303. Purdue Extension publication AY-18 allows up to 100 pounds per 1,000 square feet on higher-cut turf.

—
sq ft to treat
—
pounds of seed
—
seed bags to buy
—
fertilizer bags to buy
JobAmountBags to buy
Grass seed——
Lawn fertilizer——
Starter fertilizer——
Lime——
MEASURE ONCE

Use the same square footage for every bag.

Bring the area over from the lawn tool, and subtract patios, sheds, and beds you will not seed or treat.

EXTENSION RATES, THEN THE BAG

Start from a named source, then edit it.

Each default rate shows its university source and range. The bag label always wins when you enter it.

WHOLE BAGS

The job total rounds up once.

Leftover seed, kept cool and dry, will keep. Store leftover fertilizer as the label says, away from children and pets.

How grass seed is calculated

Convert the rate to a per-square-foot figure by dividing pounds per 1,000 square feet by 1,000, then multiply by the lawn area you will actually seed. If you turn on the 10 percent extra, that seed total is multiplied by 1.10. Bags to buy are the seed pounds divided by the bag weight, rounded up to a whole bag at the job total, not once for every 1,000 square feet. If you enter a bag label instead of a rate, the rate in pounds per 1,000 square feet is the bag weight divided by the labeled coverage, then multiplied by 1,000. The bag label always wins when you enter it. Bare patches use the new-lawn rate, as University of Illinois Extension recommends.

A 4,000 square foot tall fescue lawn, overseeded at 5 pounds per 1,000 square feet, the midpoint of Nebraska Extension’s 4 to 6 pound spring overseeding range, needs (4,000 / 1,000) × 5 = 20 pounds of seed. In 10 pound bags that is exactly 2 bags. In 7 pound bags that is 20 / 7 = 2.86, so buy 3 bags.

How fertilizer bags are calculated

The formula is the one used by Purdue Turfgrass Science, Penn State Extension, and Iowa State University Extension. Divide the target pounds of actual nitrogen per 1,000 square feet by the nitrogen percent as a decimal. That is the pounds of product per 1,000 square feet. Multiply by your area over 1,000 to get the pounds for the lawn. One bag’s coverage in square feet is the bag weight divided by pounds of product per 1,000, then multiplied by 1,000. Bags to buy are the total pounds divided by the bag weight, rounded up to a whole bag.

Purdue’s example is an 8,000 square foot lawn, 16-8-8 fertilizer, and 0.75 pound of nitrogen per 1,000 square feet. 0.75 / 0.16 = 4.6875 pounds of product per 1,000 square feet, and 4.6875 × 8 = 37.5 pounds for the lawn. Purdue rounded that example to 37 pounds. One 50 pound bag covers (50 / 4.6875) × 1,000, about 10,667 square feet, so one bag is enough and some is left over.

At a larger scale, the same formula on a 50 pound bag of 26-5-10 at 1.0 pound of nitrogen per 1,000 square feet covers (50 × 0.26 / 1.0) × 1,000 = 13,000 square feet. A 30,000 square foot lawn needs 30,000 / 13,000 = 2.3 bags, so buy 3 bags. Penn State Extension published this example as 13,200 square feet of coverage and 2.3 bags; the exact arithmetic of the shared formula is 13,000 square feet, and 2.3 bags either way.

Starter fertilizer and lime

Starter fertilizer uses the same nitrogen math at seeding. Michigan State University Extension’s 1.0 pound of nitrogen per 1,000 square feet, with an 18-24-6 starter, on 3,000 square feet is 1.0 / 0.18 = 5.56 pounds of product per 1,000, and 5.56 × 3 = 16.7 pounds. A 16 pound bag is just short, so buy 2 bags, or use a larger bag.

Lime pounds are the area over 1,000, times the soil-test pounds per 1,000. A test that calls for 75 pounds per 1,000 square feet on a 6,000 square foot established lawn is 450 pounds, which is 9 bags of 50 pounds. Because 75 is above the 50-pound cap used on established turf, the first application is 50 × 6 = 300 pounds (6 bags). The remaining 150 pounds (3 bags) wait for a later pass, in a later season or after several months, as the soil-test labs advise. On a new seedbed that will be tilled, the full amount may go on at once when the lime is mixed into the soil.

When to seed, fertilize, and lime

Cool-season seed takes best in late summer and early fall. Spring will work if you keep the seedbed moist and skip ordinary crabgrass preventers, but it is the second-best window. Iowa State University Extension and Nebraska Extension say only products labeled with siduron or mesotrione are used at seeding. Warm-season seed, sprigs, or sod go down in late spring and early summer when the soil is warm; University of Georgia Extension lists May to June. Lime can go on in spring or fall. For an established cool-season lawn, keep early-spring nitrogen light: Iowa State suggests about 0.75 pound of nitrogen per 1,000 square feet in April, and Purdue says to avoid heavy, quickly available nitrogen in March or April.

How to use the grass seed and fertilizer calculator

  1. Get the square footage, or bring it over from the lawn area tool. Subtract patios, sheds, and beds you will not seed or treat.
  2. Pick the job: thicken an existing lawn, start a new one, repair bare patches, fertilize, or apply lime from a soil test.
  3. Use the bag numbers in front of you, or start from the extension range shown for your grass and then edit it.
  4. Buy whole bags. Leftover seed, kept cool and dry, will keep; leftover fertilizer should be stored as the label says, away from children and pets.

These are planning estimates, not professional agronomic advice. Sweep product off hard surfaces after spreading, as Iowa State University Extension instructs, so it stays out of streets and drains. Follow the product label, and for lime follow a soil test.

Extension sources

Every default rate on this page comes from one of the fact sheets below. When universities disagree, the control names the source used for the default and shows the range. Nothing here is an average of several states.

Grass Seed and Fertilizer Calculator FAQ

How much grass seed do I need per 1,000 square feet?

It depends on the grass and whether you are starting a new lawn or overseeding. As a spring planning default, Nebraska Extension lists Kentucky bluegrass at 3 to 4 pounds per 1,000 square feet for a new lawn and 1 to 2 pounds when overseeding, and turf-type tall fescue at 8 to 10 pounds new and 4 to 6 pounds overseeded. Other universities publish lower bluegrass new-lawn rates, often around 1 to 2 pounds. Use the rate on your seed bag when it is listed, and use the new-lawn rate on bare patches.

How do I know how many fertilizer bags to buy?

Read the three-number analysis on the bag. The first number is the percent nitrogen. Divide the nitrogen rate you want, in pounds per 1,000 square feet, by that percent as a decimal. That is the pounds of product per 1,000 square feet. Multiply by your area over 1,000, then divide by the bag weight and round up. A common spring rate on a cool-season lawn is 0.75 pound of actual nitrogen per 1,000 square feet.

How much lime does my lawn need?

Only as much as a soil test recommends. The calculator turns that recommendation into bags and, on an established lawn, splits any rate above 50 pounds per 1,000 square feet into more than one application so the grass is not burned. It will not guess a lime rate from a pH reading alone.

What is starter fertilizer, and how much should I use?

Starter fertilizer is used at seeding. It has a nitrogen-to-phosphate ratio near 1 to 1 or 1 to 1.5. Michigan State University Extension and Illinois Extension both describe a rate of about 1 pound of actual nitrogen per 1,000 square feet at seeding. Enter the analysis on your starter bag and the same square footage you used for the seed.

Is spring a good time to seed?

It can be, but it is not the best time for cool-season grasses. Fall is more reliable because the soil is warm, the nights are cool, and weed pressure is lower. If you seed in spring, keep the surface moist until the grass is up, and do not use a preemergence herbicide unless the label says it is safe on new seed. Warm-season grasses are planted later in spring, once the soil has warmed.

Are these calculators free, and is my data uploaded?

Yes, they are free, and they always will be, with no signup. All calculations run on your device in the browser.

Yard Ruler Free yard & landscape calculators
Calculated on your device. General-purpose planning estimates — not engineering, electrical, or professional advice.
☕ Buy Me a Coffee
Yard Ruler is made by Yard Socket LLC, the same folks behind Yard Socket. When we mention our own products, we’ll always say so.